BD sensor can be pre order now,the first small batch will be available next week. Thank you very much for your support....

it detects the distance from the nozzle to bed and then adjust Z axis height in real time while printing first layer. it's not like...

This is the test for 32bit stm32 based 3d printer main board working with CAN bus module. The Pandapi V2.9 is working in standalone mode...

Hi 3D print friends, I have just finished the hardware test for the Panda Segmented Heat Bed,and now have sent out the design files and...

Here I will show you how to install ESP32_Grbl and Marlin firmware into PandaZHU/M4 at the same time that means you can switch the CNC...

New version of PandaM4 available, add on board silent cooling blower FAN and external antenna. With ESP32 as the MCU for 3D printer,not...

New version of CAN Extruder Board is now ready, beside support normal thermistor temperature sensor, it has one more chip MAX31865 that...

Not only Marlin, you can run Grbl_ESP32 (CNC controller) on PandaZHU and PandaM4 now! Maybe the next work we do is we can flash 2...

PandaCAN is an extruder control board that connect to main board with CAN interface, more resistant to noise,reduce a lot of wires for...

PandaM4 is designed to be a drop-in replacement upgrade board for the Ender 3 printers by Creality,use ESP32 as it MCU. Powerful: it has...

Wifi,MCU,Audio,8 motor drivers... all in one wifi. use esp32 as the mcu for 3D printer motherboard. it has larger memory and more...

Since the Pandapi touch screen and the MKS H43 are the same hardware,so you can download the Touchscreen UI from mks github,and flash it...

This is an independent laser motion sensor to sense filament clog or runout. There is a Micro processor on the board that read the sensor...

The MCU has bootloader now, so you can flashing firmware from webpage. and then we can switch pandapi printing and klipper printing mode...

What's new in V2.8: Support Klipper printing; Support Running marlin firmware in MCU like normal control board,but there is no SD slot,so...

there are 2 HMDI in the raspberry PI4B , we use one for 3D model display and the other for resin printing. resin printing test with...

the new Image for PI4 1/2/8GB with latest octopi and RT arm64 kernel. welcome to test. BTW, the samba shared folder server was installed...

It's an ongoing project,Use android device as the control system of the resin printer. a little like NanoDLP, but run on android,here is...

connection: Just connect 6 lines between the MAX31865 module and the EXP1 connector, and remove one resistor then solder 1 line to the...

https://www.pandapi3d.com/product-page/serial-800-480-capacitive-touch-screen-for-printer