Installed on Ender 6 with Klipper, all went fine but no distance measurement.
I2C seems to work (based on M102-S-1).
Started M102 S-6 with very small distance from metal bed. Bed goes down in small steps, but calibration data shows no measurement results.
Not sure what to do now. Is my BDsensor simply defective or is there someting else to look for?
13:03:52 $ M102 S-1
13:03:53 V1. pandapi3d.com
13:06:59 $ M102 S-6
13:06:59 // Calibrating, don't power off the printer
13:07:00 // Please Wait...
13:07:32 // Calibrate Finished!
13:07:33 // You can send command BDSENSOR_READ_CALIBRATION to check the calibration data
13:07:39 $ BDSENSOR_READ_CALIBRATION
13:07:39 1015
13:07:39 BDSensor mounted too high! 0.4mm to 2.4mm from BED at zero position is recommended
13:07:39 1015
13:07:39 BDSensor mounted too high! 0.4mm to 2.4mm from BED at zero position is recommended
13:07:40 1015
13:07:40 BDSensor mounted too high! 0.4mm to 2.4mm from BED at zero position is recommended
13:07:40 1015
13:07:40 BDSensor mounted too high! 0.4mm to 2.4mm from BED at zero position is recommended
13:07:40 1015
13:07:40 1015
13:07:40 1015
hello, did the led light on and off while it close or far away the bed? what's delay value in the section BDsensor? seems the returnd version is not completed. could you take picture of the sensor about the hardware version. you can open the shell and check the connection inside if is it v1.3 2023.12