I keep running into this with BDsensor on Klipper when trying to home or run Bed Tilt calibration lately. I've recalibrated the probe a couple of times and have been through the wiki to make sure everything is set up correctly. Any idea what I'm missing?

Urban Planning Assignment Help with BookMyEssay is vital due to the complex challenges inherent in urban planning. Rapid urbanization strains resources, leading to issues like overpopulation, traffic congestion, and inadequate infrastructure. Balancing economic growth with environmental sustainability poses a significant challenge, requiring innovative solutions in waste management, green spaces, and energy efficiency. Socio-economic disparities also challenge planners, with marginalized communities often facing inadequate housing and limited access to services. Historical and cultural preservation in rapidly developing cities requires careful consideration to maintain identity while fostering progress. Additionally, coordinating diverse stakeholders like government agencies, developers, and communities demands effective communication and collaboration strategies. BookMyEssay offers insights into these challenges, providing students with tools to address complex urban planning issues effectively. Visit Us - www.bookmyessay.com/urban-planning-assignment

BDSensor installed and *almost" perfect. M102-6 runs OK, M102-5 gives good results, with initial reading = 230 and next reading = 242. Saved settings. But when printing, the nozzle is too high off the bed. I have to baby step it down bu .5mm in order to get good bed adhesion. I've been using it like this for some weeks, and I'm OK with it, but two questions: (1) WHY is there this discrepncy? (2) Why does setting z_adjust: 0.5 (in printer.cfg under the BDSensor section) not work. I STILL have to set baby steps to -0.5 mm