Hi, i am building a 3d printer that needs to go up to 450c/500c.... I have a pt100 sensor and a signal amplifying board, now I know how to assign 5v/ground and a pin to the board on a ramps/radds to make a hi-temp printer, but I am completely lost on how to add a pt100 sensor on the panda board. if somebody could help me out a little with the wiring it would mean a lot to me. Thank you!
top of page
bottom of page
Check your wiring, and contact Mark Niu if you don't have success. The PT100 is in PandaPi, but I see no wiring examples for the PandaPi Board.