I did go to :8181, but is said the expected folder wasn't found. I've never messed with other 3D printer boards or Drivers before and thought this was much more plug-n-play than it's turning out to be. I have Version 2.0.
top of page
To test this feature, visit your live site.
TMC2208 Drivers... how do I set these up with Marlin 2.0 and Rpi4b on your latest firmware (April 25, I think)?
TMC2208 Drivers... how do I set these up with Marlin 2.0 and Rpi4b on your latest firmware (April 25, I think)?
5 answers9 replies
Like
Comments (14)
bottom of page
Mark,
Picture 1 and picture 2 in your documentation disagree. One shows Jumpers configured for UART one way, and one shows them configured another. Please clarify these configurations. As another user on this forum noted, your documentation is very light.