I am running an Adimlab Gantry S (ender 3 clone) with a Pandapi v2.5, raspberrypi4 2g and 4 tmc2208 in standalone with the newest version of the 64bit firmware. I think there may be a timing issue in stepper.h due to the increase in clock cycles from a change to 64 bit. The speed increase appears to be double but that is an estimate. Is there a way to calibrate the speed or is it a calculation in the firmware?
top of page
To test this feature, visit your live site.
With the new 64bit firmware, there seems to be an increase in stepper motor speed. This is not a change in esteps as the parts are correct
With the new 64bit firmware, there seems to be an increase in stepper motor speed. This is not a change in esteps as the parts are correct
4 answers2 replies
Like
Comments (6)
bottom of page
Thank you very much David. I've downloaded the the Raspian Desktop, but haven't imaged an SD Card yet.
I have Putty installed, so I can use SSH, but I do not know Linux. I'm capable of following instructions I see here and there, but that's it.
Thanks again.